Re: trying LTT on Linux 2.6.10

shankar wrote:
> With this,  it is working now.

Sounds good.  I'm glad you have it working.

> I would like to know if I can use  LTTng on 2.6.10 with MIPS4000.
I wouldn't know.  I'm using LTT (original) on my 2.6.11 on MIPS.
I only started using LTTng on a 2.6.16 kernel (and not on the MIPS platform).
My experience is that the instrumentation points are not too different
between LTT and LTTng, and that it is relatively straightforward to
convert from LTT to LTTng, as longs are your board support
(that is, your arch-specific instrumentation points) is OK.
When I converted from LTT to LTTng on 2.6.16, it was not
terribly difficult, but it did take a few weeks (if I recall
correctly).

Good luck!
  -- Tim

=============================
Tim Bird
Architecture Group Chair, CE Linux Forum
Senior Staff Engineer, Sony Corporation of America
=============================