Re: [PATCH 26/28] arm64: dts: qcom: eliza-mtp: Fix swapped USB QMP PHY vdda-phy/vdda-pll supplies
Abel Vesa <[email protected]>
| Newsgroups | gmane.linux.drivers.devicetree,gmane.linux.ports.arm.msm,gmane.linux.kernel |
|---|---|
| Message-ID | <tiln6lkf63i6ezelo46alawu5yxl2rqu5x7kiz2emre5g65ctr@mad73j5h5xyr> |
On 26-08-03 08:34:24, Manivannan Sadhasivam via B4 Relay wrote: > From: Manivannan Sadhasivam <[email protected]> > > The QMP PHY expects the vdda-phy supply to be the lower voltage (~0.8V) > and the vdda-pll supply to be the higher voltage (~1.2V), as used by the > UFS QMP PHY on this SoC. But these two supplies are swapped for the USB > QMP PHY on this board, feeding 1.15V to vdda-phy and 0.72V to vdda-pll. > > Fix it by swapping the two supplies back. > > Fixes: 49dab7311f57 ("arm64: dts: qcom: eliza-mtp: Enable USB and ADSP support") > Reported-by: Konrad Dybcio <[email protected]> > Assisted-by: Claude:opus-4-8 > Signed-off-by: Manivannan Sadhasivam <[email protected]> Reviewed-by: Abel Vesa <[email protected]>