[PATCH v7 1/3] dt-bindings: mmc: Extend keep-power-in-suspend beyond SDIO

keep-power-in-suspend is currently documented as SDIO-only, but the
requirement it describes -- preserving card power across a
suspend/resume cycle -- applies just as well to any card type. Drop
the SDIO-only restriction so eMMC and SD platforms can use it too.

Signed-off-by: Kamal Dasu <[email protected]>
Reviewed-by: Krzysztof Kozlowski <[email protected]>
---
Changes in v7:
  - Added Krzysztof's Reviewed-by.

Changes in v6:
  - Split into a separate, minimal patch per Ulf: just extend
    keep-power-in-suspend's scope, with no brcmstb/firmware-specific
    rationale in its description. That rationale now lives in the new
    reset-card-at-resume property instead (patch 2/3), and the two
    are set together on brcmstb rather than folded into one property.
  - Also per Ulf (applies to v4 and v5 alike): dropped the mention of
    sdio_set_host_pm_flags() and how Linux's SDIO stack happens to
    expose this at runtime -- that's a software implementation
    detail, not a hardware/platform description.

Changes in v5:
  - Added Krzysztof's Reviewed-by.

Changes in v4:
  - Dropped no-mmc-poweroff-suspend entirely and extended
    keep-power-in-suspend instead, per Krzysztof: the two properties
    described the same "don't power off across suspend/resume"
    contract.

Changes in v3:
  - Renamed from no-mmc-sleep; dropped S_A_TIMEOUT framing per Ulf.

Changes in v2:
  - New patch, replacing v1's card-level quirk, per Ulf.

 Documentation/devicetree/bindings/mmc/mmc-controller-common.yaml | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mmc/mmc-controller-common.yaml b/Documentation/devicetree/bindings/mmc/mmc-controller-common.yaml
index 3d7195e9461c..c18bf0d6a56e 100644
--- a/Documentation/devicetree/bindings/mmc/mmc-controller-common.yaml
+++ b/Documentation/devicetree/bindings/mmc/mmc-controller-common.yaml
@@ -291,7 +291,7 @@ properties:
   keep-power-in-suspend:
     $ref: /schemas/types.yaml#/definitions/flag
     description:
-      SDIO only. Preserves card power during a suspend/resume cycle.
+      Preserves card power during a suspend/resume cycle.

   wakeup-source:
     $ref: /schemas/types.yaml#/definitions/flag
--
2.34.1