Re: [PATCH] mfd: wm8350: propagate ADC read timeout instead of returning 0

On 8/5/26, Guenter Roeck wrote:
> I am not sure if this warrants fixing in a 17+ year old driver,
> unless it is observed to be a real problem. It appears to me that the
> error handling was likely not implemented on purpose.
>
> On top of that, as is seen a lot lately, this fixes a rare issue
> that is likely never going to be seen in the real world while not
> addressing the many real problems in the driver (as reported by Sashiko).

That's fair, sure. The automated review also caught a real regression
in this patch itself: reusing `ret` for the voltage value in the
power_supply get_property callbacks means a successful read returns
a nonzero value instead of 0, which breaks the normal
if (power_supply_get_property(...)) error-checking convention for
callers which is on my end.. I'll drop this patch rather than resubmit a v2 for an issue
you've said isn't worth fixing here.

Thanks,
ivy