[PATCH v2 1/2] arm64: dts: rockchip: Fix the BT clock-names on rk3399-hugsun-x99
Fabio Estevam <[email protected]>
| Newsgroups | gmane.linux.kernel,gmane.linux.drivers.devicetree,gmane.linux.ports.arm.kernel,gmane.linux.ports.arm.rockchip |
|---|---|
| Message-ID | <[email protected]> |
According to brcm,bluetooth.yaml, the correct clock-names to describe
the 32768kHz Low Power Oscillator is "lpo".
Change it accordingly to fix the following dt-schema warning:
clock-names: 'oneOf' conditional failed, one must be fixed:
['ext_clock'] is too short
'extclk' was expected
'txco' was expected
'lpo' was expected
Signed-off-by: Fabio Estevam <[email protected]>
---
Changes since v1:
- Use "lpo" name instead. (Sashiko)
arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts b/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
index 352c8efb37e0..27ebbbc66633 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
@@ -703,7 +703,7 @@ &uart0 {
bluetooth {
compatible = "brcm,bcm43438-bt";
clocks = <&rk808 1>;
- clock-names = "ext_clock";
+ clock-names = "lpo";
device-wakeup-gpios = <&gpio2 RK_PD2 GPIO_ACTIVE_HIGH>;
host-wakeup-gpios = <&gpio0 RK_PA4 GPIO_ACTIVE_HIGH>;
shutdown-gpios = <&gpio0 RK_PB1 GPIO_ACTIVE_HIGH>;
--
2.43.0