Re: [PATCH 01/15] soc: qcom: geni-se: allow selection on 32-bit ARM Qualcomm SoCs
Dmitry Baryshkov <[email protected]>
| Newsgroups | gmane.linux.drivers.devicetree,gmane.linux.ports.arm.msm,gmane.linux.kernel,gmane.linux.power-management.general,gmane.linux.kernel.clk,gmane.linux.kernel.gpio |
|---|---|
| Message-ID | <7f4qs6su5fd5ilecy4r72suk6mqvj7oouz7ahgatxthqavrfia@wxilczij4unf> |
On Sun, Aug 09, 2026 at 12:57:00PM +0530, Hardeep Sharma wrote:
> Commit e10b198a94c6 ("soc: qcom: Restrict drivers per ARM/ARM64")
> tightened QCOM_GENI_SE's dependency to ARM64 || COMPILE_TEST on the
> assumption that no ARMv7 Qualcomm SoC uses the GENI Serial Engine
> hardware.
>
> Kuno, a 32-bit ARM Cortex-A7 Qualcomm SoC, uses the GENI-based QUP
> wrapper for its debug UART, so this assumption no longer holds.
>
> Fixes: e10b198a94c6 ("soc: qcom: Restrict drivers per ARM/ARM64")
> Signed-off-by: Hardeep Sharma <[email protected]>
> ---
> drivers/soc/qcom/Kconfig | 1 -
> 1 file changed, 1 deletion(-)
>
> diff --git a/drivers/soc/qcom/Kconfig b/drivers/soc/qcom/Kconfig
> index fd4d4ecd2df0..5b3c9d31fd7f 100644
> --- a/drivers/soc/qcom/Kconfig
> +++ b/drivers/soc/qcom/Kconfig
> @@ -39,7 +39,6 @@ config QCOM_COMMAND_DB
>
> config QCOM_GENI_SE
> tristate "Qualcomm GENI Serial Engine Driver"
> - depends on ARM64 || COMPILE_TEST
depends on ARM || ARM64 || COMPILE_TEST
> default ARCH_QCOM
> help
> This driver is used to manage Generic Interface (GENI) firmware based
>
> --
> 2.43.0
>
--
With best wishes
Dmitry