[PATCH] media: staging/ipu7: return 0 for IPC messages that expect no response

ipu_buttress_ipc_send_msg() sends a command to the CSE and waits for the
send_complete completion, which the interrupt handler raises once the CSE
has executed the command. When a message does not ask for a response,
that completion is the whole story: the command went through, and the
caller should be told it succeeded.

The no-response path does the opposite. Right after the command completes
successfully it returns -EIO, turning a good send into an error. The IPU6
driver this code was derived from gets it right, since there the
no-response case simply moves on to the next message. This looks like a
slip made when the bulk loop was collapsed into a single-message helper.

Every caller today passes require_resp = true, so nothing is broken in
practice yet, but the return value is wrong and will trip up the first
no-response command that comes along. Return 0 instead.

Fixes: b7fe4c0019b1 ("media: staging/ipu7: add Intel IPU7 PCI device driver")
Signed-off-by: Sidharth (Siddhi) Sharma <[email protected]>
---
 drivers/staging/media/ipu7/ipu7-buttress.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/staging/media/ipu7/ipu7-buttress.c b/drivers/staging/media/ipu7/ipu7-buttress.c
index 40c6c8473..8b57c7c1a 100644
--- a/drivers/staging/media/ipu7/ipu7-buttress.c
+++ b/drivers/staging/media/ipu7/ipu7-buttress.c
@@ -265,7 +265,7 @@ static int ipu_buttress_ipc_send_msg(struct ipu7_device *isp,
 	}
 
 	if (!msg->require_resp) {
-		ret = -EIO;
+		ret = 0;
 		goto out;
 	}
 
-- 
2.55.0