Re: [PATCH net v1 1/1] net: dsa: realtek: use gpiod_set_value_cansleep for reset GPIO
Alvin Šipraga <[email protected]>
| Newsgroups | gmane.linux.kernel.stable,gmane.linux.kernel,gmane.linux.network |
|---|---|
| Message-ID | <[email protected]> |
On Fri, Aug 14, 2026 at 01:01:02PM +0200, Oleksij Rempel wrote: > From: Ahmad Fatoum <[email protected]> > > rtl83xx_reset_assert() and rtl83xx_reset_deassert() are only called from > the probe path, which may sleep and is not timing-critical. When the > reset GPIO is provided by a sleeping controller such as an I2C I/O > expander, gpiod_set_value() warns: > > WARNING: drivers/gpio/gpiolib.c:4030 at gpiod_set_value+0x44/0x80, CPU#1: kworker/u16:4/61 > Hardware name: B&O MAP CA33 Rev f (UNKNOWN) (DT) > Workqueue: events_unbound deferred_probe_work_func > pc : gpiod_set_value+0x44/0x80 > lr : rtl83xx_probe+0x1d8/0x3a0 > Call trace: > gpiod_set_value+0x44/0x80 (P) > rtl83xx_probe+0x1d8/0x3a0 > realtek_mdio_probe+0x24/0xa0 > mdio_probe+0x38/0x78 > really_probe+0xc4/0x3e0 > __driver_probe_device+0x15c/0x1b8 > driver_probe_device+0xb4/0x120 > __device_attach_driver+0xb8/0x1a0 > bus_for_each_drv+0x88/0xf0 > __device_attach+0xa0/0x1d8 > device_initial_probe+0x54/0x68 > bus_probe_device+0x38/0xa0 > deferred_probe_work_func+0xb8/0x120 > process_one_work+0x184/0x4e8 > worker_thread+0x188/0x308 > kthread+0x130/0x150 > ret_from_fork+0x10/0x20 > > Switch both helpers to gpiod_set_value_cansleep() so such a reset GPIO can > be used without triggering the warning. > > The reset GPIO has been driven with the non-sleeping gpiod_set_value() > since the driver was added in v4.19. The call has since been refactored > across several files - from realtek-smi.c / realtek-mdio.c into the common > rtl83xx.c module and then into the rtl83xx_reset_assert() and > rtl83xx_reset_deassert() helpers (both in v6.9). This patch therefore > applies as-is only to kernels that carry those helpers (v6.9+); older > stable kernels need the same gpiod_set_value_cansleep() conversion at the > corresponding open-coded call sites. > > Fixes: d8652956cf37 ("net: dsa: realtek-smi: Add Realtek SMI driver") > Cc: <[email protected]> # 6.9.x > Signed-off-by: Ahmad Fatoum <[email protected]> > Co-developed-by: Oleksij Rempel <[email protected]> > Signed-off-by: Oleksij Rempel <[email protected]> > --- > drivers/net/dsa/realtek/rtl83xx.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) Reviewed-by: Alvin Šipraga <[email protected]>