Re: Bering 6.2.x and miniPCIe modules

Hi Erich,
thank you for your info.

Meantime I received newly compiled kernel and modules from KP and 
replaced these "old" in geode 6.2.4.

After boot I could see created ttyACM0 and ttyACM1 devices and also
cat /sys/kernel/debug/usb/devices
shows a lot of information.

So, it seems to be solved.

Thank you :-)

Tomorrow afternoon I will test communication and watchdog geodewdt 
module as well.

Cheers
Otto

Dne 01.02.2020 v 20:12 Erich Titl napsal(a):
> Hi Otto
> 
> I had a look at the ALIX documentation and _believe_ that the miniPCIe
> device is linked to the USB device.
> 
> I then had a look at my current config settings and compared the i486
> and the geode USB settings.
> 
> I found the following
> 
> < # CONFIG_USB_PCI is not set
> ---
>> CONFIG_USB_PCI=y
> 
> I can confirm that there have been USB config changes between 6.1.8 and
> 6.2.0. So it is possible that you are affected by these changes.
> 
> cheers
> 
> ET
> 
> 
> 


------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/