Re: Leaf 7.2.1: Webconf login does not appear

Hello Tim, List

As you see I ran some tests on 7.2.1 I didn't have to install the libcap
and libcap-tools to get eth0 with a proper IP address. I just made sure
eth0 and eth1 were properly assigned, it turned out I only had to swap the
rj45 cables, and check both eth had the right ip address.

In Mr. Graziano's case, he is right to say he can connect to the webconf
without credentials being asked, but he gets connected to the webconf
password page only, and can't use any of the webconf links before setting a
Username and Password.

bye
jrb.


On Thu, May 18, 2023 at 11:03 PM Timothy Wegner <[email protected]> wrote:

> jeanrocco jr wrote
>
>  On Wed, Apr 5, 10:48 AM 2023, Timothy Wegner ran some tests on lighttpd
> > and did not report this problem.
> >
>
> Yes I did run some tests to verify that the Leaf team had repaired
> something that had broken, but I didn't look at the issue Graziano mentions
> (webconf not asking for credentials). I just checked, and discovered that
> when I login to Leaf using webconf, indeed I am not asked for credentials.
>
> Alas, I am leaving for a three week trip (back June 11), so I can't look
> into this more now. When I get back I will read any discussion on the list
> and install new versions (if any), and test more thoroughly.
>
> Tim Wegner
>
> ------------------------------------------------------------------------
> leaf-user mailing list: [email protected]
> https://lists.sourceforge.net/lists/listinfo/leaf-user
> Support Request -- http://leaf-project.org/
>

------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/