7.5.0 cannot boots

Hi list,

I have tried to install leaf 7.5.0 x86_64 - VGA console - on an 
industrial PC without success; after the POST, nothing appears on VGA 
console and it reboot after few seconds.

This machine is based on a SBC with CPU Intel Atom E3825, 4 Gigabit 
Intel I211 and with  firmware configured to boot in "UEFI and Legacy" 
mode. (Firmware BIOS UEFI v2.40 PI 1.3 by American Megatrends)

On first try, I have installed it in "legacy mode" (single MBR 
partition, syslinux installed on MBR), but the system does not boot 
correcty (it reboots after few seconds)

As second chance, I have installed it in "UEFI" mode (sigle partition, 
UEFI configured on storage) but it do not start as well (it always 
reboot after some seconds).

The same system boots correctly using a 7.3.1 version (in "legacy mode" 
and in "UEFI" mode as well).

Are there some problems in new 7.5.0 version and UEFI systems? is the 
new kernel version enabled to support EFI?

Thanks in advance

Ciao

Graziano

-- 

Graziano Brioschi

Outland s.a.s.
sede operativa:
Via A. Don Rocca, 13
20030, Senago (MI)
tel: 02 9948 6014
mobile: 328 8382622
email: [email protected]
--> U4E <--



------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/