Re: [leaf-wisp] wireless

Ok, so I forgot to add the netcs0 interface to /etc/init.d/dhcpd.  Things 
are working fine with senao.

But I still can't get the demarctech to work but I know it works with 
pebble.  Does wispdist only support certain intersil prism 2 cards?  This is 
very odd since pebble and wispdist both use hostap.  Do I need to change 
something for the brand of wireless card somewhere?


>From: "Shubho Biswas" <[email protected]>
>To: [email protected]
>Subject: Re: [leaf-wisp] wireless
>Date: Fri, 26 Mar 2004 13:36:49 -0500
>
>This is a bit strange.  I just changed the wireless card to a senao and my 
>laptop could connect.  But it couldn't get and IP address and apstats shows 
>nothing.  I tried changing /etc/dhcpd.conf but when I rebooted, my changes 
>were lost.  Maybe a save config will help.
>
>So I tried the demarctech with pebble again and it's working!  But not with 
>wispdist.  I'll see what else I can find out about this card.
>
>
>>From: Vladimir Ivaschenko <[email protected]>
>>To: Shubho Biswas <[email protected]>
>>CC: [email protected]
>>Subject: Re: [leaf-wisp] wireless
>>Date: Fri, 26 Mar 2004 20:22:46 +0200
>>
>>Ok,
>>
>>So you cannot see the associated client in the AP statistics?
>>
>>Shubho Biswas wrote:
>>>soekris 2511 with demarctech wireless card (intersil prism 2 based).  2 
>>>eth ports with only 1 active but I'm hoping not even to use it.  I just 
>>>want to see if clients can associate to the wireless card.  (I have tried 
>>>this wireless card with pebble on the same board.)
>>>
>>>
>>>>From: Vladimir Ivaschenko <[email protected]>
>>>>To: Shubho Biswas <[email protected]>
>>>>CC: [email protected]
>>>>Subject: Re: [leaf-wisp] wireless
>>>>Date: Fri, 26 Mar 2004 20:09:35 +0200
>>>>
>>>>
>>>>A description of hardware that you use would be nice.
>>>>
>>>>Shubho Biswas wrote:
>>>>
>>>>>Hey folks,
>>>>>
>>>>>I'm wondering what's the simplest way to get a wireless network using 
>>>>>wispdist.  I downloaded the latest tarball and I'm trying to configure 
>>>>>it.  All I want to do is see if my clients can associate so I don't 
>>>>>need the ethernet to work.  I  just need netcs0 to hand out IP's.
>>>>>
>>>>>So I set my wireless card to Master mode but my clients can't seem to 
>>>>>associate.  What else do I need to do? Do I need to set dhcpd 
>>>>>somewhere? (netcs0 is configured to start during boot with a static 
>>>>>IP.)
>>>>>
>>>>>Shubho
>>>>>
>>>>>_________________________________________________________________
>>>>>Free yourself from those irritating pop-up ads with MSn Premium. Get 
>>>>>2months FREE*  
>>>>>http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>-------------------------------------------------------
>>>>>This SF.Net email is sponsored by: IBM Linux Tutorials
>>>>>Free Linux tutorial presented by Daniel Robbins, President and CEO of
>>>>>GenToo technologies. Learn everything from fundamentals to system
>>>>>administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
>>>>>_______________________________________________
>>>>>leaf-wisp-dist mailing list
>>>>>[email protected]
>>>>>https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
>>>>>
>>>>
>>>>
>>>>--
>>>>Best Regards,
>>>>Vladimir Ivashchenko
>>>>ThunderWorx - www.thunderworx.com
>>>>Senior Systems Designer/Engineer
>>>>
>>>
>>>_________________________________________________________________
>>>MSN Premium helps eliminate e-mail viruses. Get 2 months FREE*  
>>>http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines
>>>
>>>
>>>
>>>
>>>-------------------------------------------------------
>>>This SF.Net email is sponsored by: IBM Linux Tutorials
>>>Free Linux tutorial presented by Daniel Robbins, President and CEO of
>>>GenToo technologies. Learn everything from fundamentals to system
>>>administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
>>>_______________________________________________
>>>leaf-wisp-dist mailing list
>>>[email protected]
>>>https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
>>>
>>
>>
>>--
>>Best Regards,
>>Vladimir Ivashchenko
>>ThunderWorx - www.thunderworx.com
>>Senior Systems Designer/Engineer
>>
>
>_________________________________________________________________
>MSN Premium: Up to 11 personalized e-mail addresses and 2 months FREE*   
>http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines
>
>
>
>-------------------------------------------------------
>This SF.Net email is sponsored by: IBM Linux Tutorials
>Free Linux tutorial presented by Daniel Robbins, President and CEO of
>GenToo technologies. Learn everything from fundamentals to system
>administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
>_______________________________________________
>leaf-wisp-dist mailing list
>[email protected]
>https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist

_________________________________________________________________
http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines



-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click