Re: [leaf-wisp] Firewalling the wifi ports
Robert Boardman <[email protected]>
| Newsgroups | gmane.linux.leaf.wisp-dist |
|---|---|
| Message-ID | <[email protected]> |
Steve Wright wrote: >On Tue, 2004-05-11 at 04:56, Robb wrote: > > >>just one question >> >> >> >>one connection is directly on a wireless Comunity network, an the ethernet is directly on my lan, I don't want to NAT as I will be providing a VOIP server for the comunity, so I want to route for sip and RTP, anyway, how would I go about adding firewall rules to only allow certain ports in and out? >> >> > > >I had thought that you cannot route a private address into the public >address space.. You must translate it at some point, even if only >one-to-one translate (not full NAT/MASQ) > > >best, >Steve > > > > >------------------------------------------------------- >This SF.Net email is sponsored by Sleepycat Software >Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to >deliver higher performing products faster, at low TCO. >http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3 >_______________________________________________ >leaf-wisp-dist mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist > > my private network is on 10.x..x..x and the community wireless network is on 192.168.x.x so they can either NAT or route , I would prefer to route but only certain ports to certain hosts can this be done, is there a tool I can use to create the firewall rules? Thanks Robb ------------------------------------------------------- This SF.Net email is sponsored by Sleepycat Software Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver higher performing products faster, at low TCO. http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3