Re: [leaf-wisp] Zebra/ospf

Hmmm
I think it'll be better if you can paste :
- ip addr
- ospf sh run
of both routers to your mail so we can "imagine" what you did.

Sincerely
-bino-
----- Original Message -----
From: "Ray Gwinn" <[email protected]>
To: "Vladimir Ivashchenko" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, June 15, 2004 8:56 AM
Subject: Re: [leaf-wisp] Zebra/ospf


> I am wondering if I have basic radio setup problem.  The two radios for
the node to
> hode hop are on the same channel (11) and in master mode.  Is this
correct?
>
> > By the way, a requirement of OSPF is that interface
> > network/netmask should be the same on both of the routers.
>
> I have tried many variations.  Currently the interface on one router is
set to
> 10.0.100.1/24, and 10.0.101.1/24 on the other router.  The network is not
the same,
> but the netmask is.  I have tried one big network 10.0.0.0/8 network also,
with /8
> netmask on all IPs, and still no luck.
>
> Ray
>
> On 14 Jun 2004 at 23:20, Vladimir Ivashchenko wrote:
>
> > Hi,
> >
> > You can configure the OSPF authentication key using the menu, or
> > using command line - look at " ip ospf message-digest-key"
> > interface subcommand.
> >
> > Anyway, I'm interested to see output "sh ip ospf neigh" command.
> >
> > By the way, a requirement of OSPF is that interface
> > network/netmask should be the same on both of the routers.
> >
> > Ray Gwinn wrote about "Re: [leaf-wisp] Zebra/ospf":
> >
> > > > Make sure that OSPF key is the same on both nodes, and check that
> > >
> > > I see nothing in the default conf files, or the zebra documentation
about an
> > > "OSPF key". Can you give more detail?
> > >
> > > Ray
> > >
> > > On 13 Jun 2004 at 14:38, Vladimir Ivaschenko wrote:
> > >
> > > >
> > > > OSPF routing should work by default.
> > > >
> > > > Make sure that OSPF key is the same on both nodes, and check that
> > > > routing tables are correct by doing "ip route". Note that if OSPF is
> > > > working you will have routes with "proto zebra" in the list.
> > > >
> > > > Ray Gwinn wrote:
> > > > > Vladimir, I have one wisp-disp node up and running fine.  This
node has
> > > > > an internet feed via eth0.  All hardware is Soekris 4521.
> > > > >
> > > > > I have now up a second node.  This second node is wireless only.
That
> > > > > is, the second node's internet feed is one of the radios connected
to a
> > > > > small beam pointing at the first (working) node.  User's can
associate
> > > > > with the second node, but there seems to be a routing problem.
> > > > >
> > > > > My question is, should the default wisp-disp zebra/ospf configs
work on
> > > > > both nodes? If not, can you provide any clues about configuring
> > > > > zebra/ospf for the two nodes?
> > > > >
> > > > > Ray
> > > > >
> > > > >
> > > > >
> > > > > -------------------------------------------------------
> > > > > This SF.Net email is sponsored by the new InstallShield X.
> > > > >>From Windows to Linux, servers to mobile, InstallShield X is the
> > > > > one installation-authoring solution that does it all. Learn more
and
> > > > > evaluate today! http://www.installshield.com/Dev2Dev/0504
> > > > > _______________________________________________ leaf-wisp-dist
mailing
> > > > > list [email protected]
> > > > > https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
> > > > >
> > > >
> > > >
> > > > --
> > > > Best Regards,
> > > > Vladimir Ivashchenko
> > > > ThunderWorx - www.thunderworx.com
> > > > Senior Systems Designer/Engineer
> > > >
> > > >
> > > >
> > > > -------------------------------------------------------
> > > > This SF.Net email is sponsored by the new InstallShield X.
> > > > >From Windows to Linux, servers to mobile, InstallShield X is the
> > > > one installation-authoring solution that does it all. Learn more and
> > > > evaluate today! http://www.installshield.com/Dev2Dev/0504
> > > > _______________________________________________
> > > > leaf-wisp-dist mailing list
> > > > [email protected]
> > > > https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
> > >
> > >
> >
> > --
> > Best Regards,
> > Vladimir Ivashchenko
> > ThunderWorx - www.thunderworx.com
> > Senior Systems Designer/Engineer
> >
> >
> > -------------------------------------------------------
> > This SF.Net email is sponsored by The 2004 JavaOne(SM) Conference
> > Learn from the experts at JavaOne(SM), Sun's Worldwide Java Developer
> > Conference, June 28 - July 1 at the Moscone Center in San Francisco, CA
> > REGISTER AND SAVE! http://java.sun.com/javaone/sf Priority Code NWMGYKND
> > _______________________________________________
> > leaf-wisp-dist mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
>
>
>
>
> -------------------------------------------------------
> This SF.Net email is sponsored by The 2004 JavaOne(SM) Conference
> Learn from the experts at JavaOne(SM), Sun's Worldwide Java Developer
> Conference, June 28 - July 1 at the Moscone Center in San Francisco, CA
> REGISTER AND SAVE! http://java.sun.com/javaone/sf Priority Code NWMGYKND
> _______________________________________________
> leaf-wisp-dist mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
>
>
> __________ NOD32 1.789 (20040614) Information __________
>
> This message was checked by NOD32 Antivirus System.
> http://www.nod32.com
>
>



-------------------------------------------------------
This SF.Net email is sponsored by The 2004 JavaOne(SM) Conference
Learn from the experts at JavaOne(SM), Sun's Worldwide Java Developer
Conference, June 28 - July 1 at the Moscone Center in San Francisco, CA
REGISTER AND SAVE! http://java.sun.com/javaone/sf Priority Code NWMGYKND