Re: [leaf-wisp] Zebra/ospf

> So you have master and client on the same CPE?

Yes, remember I am a novice.  I have looked father and I see the managed interface is 
connecting to the master interface on the same node.  BUT, only if the other node is not 
up and running.  Info follows the text of this message.

I now see the managed interface is changing frequencies from channel 11 to channel 6, 
to match the master it has found.  If there is a way to stop the channel change? That 
would seem to correct my problem.

My intent with this configuration is that the master interface is for users to connect with.  
The managed interface is for the internet feed.  The master interface will be connected to 
an omni antenna. The managed interface will be connected to a beam antenna. At this 
time the two soefris 4521s are in the same lab, covers removed.

Restarting the networking on the node with the managed interface is enough to allow the 
two nodes to start communicating.

See below for more info.

Ray

Master node under is always as follows:

netcs0    Mode:Master  Frequency:2.412GHz  Access Point: 00:02:6F:08:21:E1
netcs1    Mode:Master  Frequency:2.462GHz  Access Point: 00:02:6F:08:21:DF

Managed node when all is working, master node booted first.

netcs0    Mode:Master  Frequency:2.437GHz  Access Point: 00:02:6F:08:11:64
netcs1    Mode:Managed  Frequency:2.462GHz  Access Point: 00:02:6F:08:21:DF

Managed node, no communications, managed booted first.

netcs0    Mode:Master  Frequency:2.437GHz  Access Point: 00:02:6F:08:11:64
netcs1    Mode:Managed  Frequency:2.437GHz  Access Point: 00:02:6F:08:11:64




-------------------------------------------------------
This SF.Net email is sponsored by The 2004 JavaOne(SM) Conference
Learn from the experts at JavaOne(SM), Sun's Worldwide Java Developer
Conference, June 28 - July 1 at the Moscone Center in San Francisco, CA
REGISTER AND SAVE! http://java.sun.com/javaone/sf Priority Code NWMGYKND