Re: upgrading glibc-2.40 -> 2.41
| Newsgroups | gmane.linux.lfs.beyond.support |
|---|---|
| Message-ID | <[email protected]> |
On 6/25/25 8:43 PM, William Harrington ([email protected] via blfs-support Mailing List) wrote: > On Wed, 25 Jun 2025 16:00:41 +0200 > "tjoen" ([email protected] via blfs-support Mailing List) <[email protected]> wrote: > >> On 6/25/25 2:48 PM, Rainer Fiebig ([email protected] via blfs-support >> Mailing List) wrote: >> .. >>>> I am afraid rebuilding the whole system is unavoidable >>> Back in February I updated from -2.35 to -2.41, following the >>> instructions in the book. There was an initial issue with "fixed" >>> headers (short thread here on blfs-support) but that was about all. The >>> only packages I rebuilt at the time were the kernel and gcc which I >>> updated to -11.5.0. No problems since then. >> >> I have decided to rebuild according to the books >> with the only difference RPM-based, Python with pip and >> perl with CPAN > > Greetings, > > Didn't want to learn how to debug or did you just give up and rebuild? > > Sounds pretty simple if you did a debug and find what was causing the segefault, Have fun spending the next 72+ hours rebuilding > > Sincerely, > > William Harrington > > He should not have to to a rebuild since he was using rpm. All that would be needed is to reinstall the glibc-2.40 package. -- Hindi madali ang maging ako -- http://lists.linuxfromscratch.org/sympa/info/blfs-support Unsubscribe: See the above information page