Re: Building a GUI - where to start?

Hi folks. So. I've been working on the Xorg (BLFS 12.4, chapter 24)
installation this weekend, and have run into an error. It might be worth
noting that I'm building on LFS 13.0-rc1.

I made my way to installing Mesa 25.1.8, and had an error which said that
rustc could not be found. So, I went down the rabbit hole installing rust.
Well, I think I have rust installed properly (I did not see any errors), and
rather than installing LLVM separately, I used the shipped version (I think -
see below), based on the editor's note at
https://wiki.linuxfromscratch.org/blfs/wiki/rust, which says that if LLVM is
not separately installed, rust will install it's own version. The reason I
mention this, is that I have a new error when attempting to install Mesa:

Run-time dependency libclc found: NO. So, I went to install libclc, and that's
when I encountered the following issue with LLVM:

cmake error: could not find a package configuration file provided by LLVM with
any of the following names: LLVMConfig.cmake, llvm-config.cmake. So I'm
doubting now whether rust installed properly, or at least put LLVM in a
findable spot when it did.

Additionally, I have a run-time dependency libglvnd that is not found when
installing Mesa. There is some wording about that in the book too, but it's
not clear to me how I should proceed.

Any ideas?

*Note that some of the error messages are truncated to the relevant parts
since I have to manually type the output from my VM.*

-- 
http://lists.linuxfromscratch.org/sympa/info/blfs-support
Unsubscribe: See the above information page