Re: BLFS, After pam and systemd
| Newsgroups | gmane.linux.lfs.beyond.support |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 2026-08-20 at 01:57 +0000, Richard wrote:
> Been there, done that...
>
> In pcap install, you want to back this out:
>
> mv -v /etc/pam.d/system-auth{,.bak} &&
> cat > /etc/pam.d/system-auth << "EOF" &&
> # Begin /etc/pam.d/system-auth
>
> auth optional pam_cap.so
> EOF
> tail -n +3 /etc/pam.d/system-auth.bak >> /etc/pam.d/system-auth
I do have the modified system-auth, and it works for me...
I cannot reproduce ATM. What I have done differently is that I have
built cracklib and libpwquality before shadow (cracklib even before
pam), and libcap-pam after systemd. I use jhalfs, so that instructions
should be the same as the ones obtained with "dump-commands".
I'll try to reproduce exactly what you have done, but this may take
some time because I need to set up a new VM for this...
Pierre
--
http://lists.linuxfromscratch.org/sympa/info/blfs-support
Unsubscribe: See the above information page