Re: building an LFS/BLFS system using porg

On Tue, Oct 28, 2014 at 4:39 PM, Roger Koehler <[email protected]> wrote:
> On Tue, Oct 28, 2014 at 4:30 PM, Roger Koehler <[email protected]> wrote:
>> On Tue, Oct 28, 2014 at 11:22 AM, Roger Koehler <[email protected]> wrote:
>>> On Tue, Oct 28, 2014 at 8:43 AM, Roger Koehler <[email protected]> wrote:
>>>> I am excited to try it!  My plan is to install it at the end of LFS chapter
>>>> 5 and then use it to install the entire system!  I may run into issues.
>>>
>>> Step 1:
>>>
>>> So, after installing xz, do this (as root):
>>>
>>> mkdir /mnt/lfs/var/log/porg
>>> ln -sv /mnt/lfs/var/log/porg /var/log/porg
>>> ./configure --prefix=/tools --disable-grop
>>> make
>>> make install
>>
>> Step 2:
>>
>> After creating all of the standard directories, links, and
>> configuration files, the first real installation is the Linux API
>> headers which amounts to a simple copy command:
>>
>> porg -lp linux-api-headers-3.16.6 "cp -rv dest/include/* /usr/include"
>
> One more quick note.  The following command can be used so as not to
> have to type in the package name if the build directory name is good
> enough:
>
> porg -lD "make install"

Changed "install directory" to "build directory" above.
-- 
http://lists.linuxfromscratch.org/listinfo/lfs-chat
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page