Re: glibc-2.42 instuctions don't clearly say where to build Time Zone data

"Rainer Fiebig" ([email protected] via lfs-support Mailing List) <[email protected]> Sat, 29 Nov 2025 15:51:09 +0100
Newsgroups gmane.linux.lfs.support
Message-ID <[email protected]>
Am 29.11.25 um 02:57 schrieb Richard Henschel ([email protected]
via lfs-support Mailing List):
> 
> On 11/28/25 00:28, Bruce Dubbs ([email protected] via lfs-support
> Mailing List) wrote:
>> On 11/26/25 7:16 PM, "Richard" ([email protected] via
>> lfs-support Mailing List) wrote:
>>> The instructions work fine, just not clear where:
>>>
>>> Add 'cd glibc-2.42/timezone' directory or ../timezone if in the 'build'
>>> directory at the top.
>>> There is also a timezone directory in the 'build' directory where
>>> this won't
>>> work.
>>
>> As stated in Part III, page iii, General Compilation Instructions,
>> Second 'Important' note:
>>
>> 3. For each package:
>>
>>    a. Using the tar program, extract the package to be built.
>>
>>    b. Change to the directory created when the package was extracted.
>>
>>    ...
>>
>> So we assume starting in the directory  $LFS/sources/glibc-2.42/, or
>> in Chapters 7 and 8 just /sources/glibc-2.42.
>>
>> The only time we say to change directories is
>>
>>   mkdir -v build
>>   cd       build
>>
>> Don't read things into the instructions that are not there.  All other
>> commands use either relative directory locations or absolute directory
>> paths.
>>
>>   -- Bruce
>>
> True, but you never tell the installer to "cd timezone" directory in the
> root of the package source.  You should.  I only did because I did
> install of libc years ago and knew there was such a directory, and got a
> clue when did "tar -xf ../../tzdata2025b.tar.gz" showing that I was
> supposed to be in a subdirectory under the source root.  A newbie might
> not catch that.  The instruction block should be:
I think you got this wrong.  If the user follows the instructions he is
still in the  /build  directory when the time-zone-data are untarred.
And the time-zone-data are untarred into this directory.  The program
"zic" which is then used to compile/install the timezones has already
been installed at this point with "make install".  Thus it is neither
necessary nor would it make sense to "cd timezone".


Rainer

-- 
http://lists.linuxfromscratch.org/sympa/info/lfs-support
Unsubscribe: See the above information page