Re: Mohamad-Reza , Iran kernel 2.6.35-28-generic
Antonio Olivares <[email protected]>
| Newsgroups | gmane.linux.linmodem |
|---|---|
| Message-ID | <[email protected]> |
Mohamad-Reza,
scanModem reports that you have a supported modem via hsfmodem drivers.
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset detected on
NAME="Audio device: Intel Corporation N10/ICH 7 Family High Definition
Audio Controller "
CLASS=0403
PCIDEV=8086:27d8
SUBSYS=1025:012f
IRQ=43
HDA2=00:1b.0
SOFT=8086:27d8.HDA
CodecDiagnosed=Conexant_
HDAchipVendorID=14f1
CHIP=0x14f12c06
IDENT=hsfmodem
Driver=hsfmodem-drivers
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation N10/ICH 7 Family High
Definition Audio Controller
Primary device ID: 8086:27d8
Subsystem PCI_id 1025:012f
Softmodem codec or chipset from diagnostics: Conexant_0x14f12c06
from Archives:
The HDA card softmodem chip is 0x14f12c06
Support type needed or chipset: hsfmodem
Writing DOCs/Intel.txt
For owners of a Dell PCs with Conexant HSF modems, a driver source
package with full speed enabled is available, but requires driver
compiling. Read DOCs/Conexant.txt
Modem support packages from Linuxant include resources for compiling drivers.
If an installer package matching your kernel_version is not provided,
just install a generic code package.
From http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php
download hsfmodem-7.80.02.05full_k2.6.35_28_generic_ubuntu_i386.deb.zip
Under Linux unpack with:
$ unzip hsfmodem*.zip
Then install with:
$ sudo dpkg -i hsfmodem*.deb
Subsequently, the modem should be found with
$ sudo wvdialconf /etc/wvdial.conf
Edit in your personal information with:
$ sudo gedit /etc/wvdial.conf
and try dialing out with:
$ sudo wvdial.
See DOCs/Testing.txt for details.
The directions following below need only be pursued, if the above
procedures are not adequate.
Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to find the
hsfmodem package matching your System. For several Linux distros, there are
precompiled drivers matched to specific kernels. These have within the FileName,
your KernelVersion: 2.6.35_28_generic
They can be found through
http://www.linuxant.com/drivers/hsf/full/downloads.php
A more precise location may be given a few paragraphs below.
If an EXACT Match with your your KernelVersion is not found, one of the
"Generic packages with source" near the bottom of the page must be used.
Downloaded packages must be moved into the Linux partition (home folder is OK)
and unzipped with:
unzip hsf*.zip
The installation command for a .deb suffic packages is, with root/adm
permission:
sudo dpkg -i hsf*.deb
while for .rpm suffix it is, with:
rpm -i hsf*.rpm
Read DOCs/Conexant.txt
Download the file:
http://www.linuxant.com/drivers/hsf/full/archive/hsfmodem-7.80.02.06full/hsfmodem_7.80.02.06full_i386.deb.zip
Use Method B in installation instructions:
http://www.linuxant.com/drivers/hsf/install.php
METHOD B: DEBIAN PACKAGE (*.deb)
If you have obtained the driver package in DEBIAN format:
1. install the package with "dpkg -i hsfmodem_{version}_{arch}.deb",
if apt-get or some other tool hasn't already done it for you.
2. if necessary, run "hsfconfig" to complete the installation, enter
license information, or to change your modem's configuration.
If you need to rebuild the Debian generic package from source, you can
get the TAR package, and from the top directory run: "make debdist". A
pre-compiled DEB package for the currently running kernel can be built
using "make debprecomp" instead.
Regards,
Antonio
On Thu, Apr 21, 2011 at 1:10 AM, Mohamad Ardakani <[email protected]> wrote:
> Hi
> Can you help me use my modem ?