Re: Tracy LaVere USA kernel 2.6.38-8-generic
Antonio Olivares <[email protected]>
| Newsgroups | gmane.linux.linmodem |
|---|---|
| Message-ID | <[email protected]> |
Tracy,
scanModem reports that you have an ESS modem:
For candidate card in slot 02:0c.0, firmware information and bootup
diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
02:0c.0 125d:2838 148d:1052 Communication controller: ESS Technology
ES2838/2839 SuperLink Modem
It also seems that you have a usb device loaded:
Potentially useful modem drivers now loaded are:
cdc_acm
You may try to use
$ sudo wvdialconf /etc/wvdial.conf
and see if that detects the modem port, as the device may be a usb modem?:
ID 0572:1280 Conexant Systems (Rockwell), Inc.
Support type needed or chipset:
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.5.2
and the compiler used in kernel assembly: 4.5.2
linux-headers-2.6.38-8-generic resources needed for compiling are not
manifestly ready!
If compiling is necessary packages must be installed, providing:
linux-headers-2.6.38-8-generic
You may also need linux-headers matching your kernel. Output of
scanModem for your ESS modem is not complete.
There are some packages for ess here:
http://linmodems.technion.ac.il/packages/ess/
however the latest drivers are over at
http://tx.technion.ac.il/~raindel/
Download the latest and give it a shot:
http://tx.technion.ac.il/~raindel/ess_2.6-v0.6.tar.gz
Regards,
Antonio
On Sat, May 14, 2011 at 9:46 AM, Tracy LaVere <[email protected]> wrote:
>
>