Re: How to configure slmodem for PRI

Ahmed,

I apologize for not knowing  about PRI as to know how to help you.  I
am forwarding your message to list Linmodems [email protected] as
some other folks might know more and be able to help you.

Regards,

Antonio

On 5/19/11, Ahmed Munir <[email protected]> wrote:
> Hi,
>
> Need to know, which parameters or commands required for configuring an ISDN
> PRI? Where I'm trying to use PRI single channel as modem one. My commands
> are listed down below and as I try to run an application I'm getting a
> message "No Carrier". The application I'm using is Qpage for paging
> messages.
>
> modem=ttya
>    device=/dev/ttySL1
>    initcmd=ATZ=E1Q0+FCLASS=0
> service=abc
>    device=ttya
>    baudrate=9600
>    parity=none
>    maxtries=3
>    maxmsgsize=255
>    maxpages=9
>    allowpid=true
>    phone=14089612819
>
> The way I'm using slmodem is that I'm binding softmodem with each PRI
> channel as listed below;
> slmodemd -c=USA /dev/dahdi/1
>
> In return it creates a softlink i.e. /dev/ttySL1. Further added, my above
> configuration is working fine on us robotics usbmodem.
>
>
> Please assist me in this problem, I'm stuck in this problem for many days.
>
> --
> Regards,
>
> Ahmed Munir
>