Re: How to configure slmodem for PRI

Ahmed,

slmodem, like most of the other soft modems, works at a sample rate of 
9600/s. A PRI works at 8000 samples/s.

Steve


On 05/19/2011 10:56 PM, Antonio Olivares wrote:
> Ahmed,
>
> I apologize for not knowing  about PRI as to know how to help you.  I
> am forwarding your message to list Linmodems [email protected] as
> some other folks might know more and be able to help you.
>
> Regards,
>
> Antonio
>
> On 5/19/11, Ahmed Munir<[email protected]>  wrote:
>> Hi,
>>
>> Need to know, which parameters or commands required for configuring an ISDN
>> PRI? Where I'm trying to use PRI single channel as modem one. My commands
>> are listed down below and as I try to run an application I'm getting a
>> message "No Carrier". The application I'm using is Qpage for paging
>> messages.
>>
>> modem=ttya
>>     device=/dev/ttySL1
>>     initcmd=ATZ=E1Q0+FCLASS=0
>> service=abc
>>     device=ttya
>>     baudrate=9600
>>     parity=none
>>     maxtries=3
>>     maxmsgsize=255
>>     maxpages=9
>>     allowpid=true
>>     phone=14089612819
>>
>> The way I'm using slmodem is that I'm binding softmodem with each PRI
>> channel as listed below;
>> slmodemd -c=USA /dev/dahdi/1
>>
>> In return it creates a softlink i.e. /dev/ttySL1. Further added, my above
>> configuration is working fine on us robotics usbmodem.
>>
>>
>> Please assist me in this problem, I'm stuck in this problem for many days.
>>
>> --
>> Regards,
>>
>> Ahmed Munir
>>