Re: How to configure slmodem for PRI
Marvin Stodolsky <[email protected]>
| Newsgroups | gmane.linux.linmodem |
|---|---|
| Message-ID | <[email protected]> |
Ahmed, ISDN modems are not included in the hardware this List supports. See http://tldp.org/HOWTO/Modem-HOWTO-17.html MarvS On Thu, May 19, 2011 at 10:56 AM, Antonio Olivares <[email protected]> wrote: > Ahmed, > > I apologize for not knowing about PRI as to know how to help you. I > am forwarding your message to list Linmodems [email protected] as > some other folks might know more and be able to help you. > > Regards, > > Antonio > > On 5/19/11, Ahmed Munir <[email protected]> wrote: >> Hi, >> >> Need to know, which parameters or commands required for configuring an ISDN >> PRI? Where I'm trying to use PRI single channel as modem one. My commands >> are listed down below and as I try to run an application I'm getting a >> message "No Carrier". The application I'm using is Qpage for paging >> messages. >> >> modem=ttya >> device=/dev/ttySL1 >> initcmd=ATZ=E1Q0+FCLASS=0 >> service=abc >> device=ttya >> baudrate=9600 >> parity=none >> maxtries=3 >> maxmsgsize=255 >> maxpages=9 >> allowpid=true >> phone=14089612819 >> >> The way I'm using slmodem is that I'm binding softmodem with each PRI >> channel as listed below; >> slmodemd -c=USA /dev/dahdi/1 >> >> In return it creates a softlink i.e. /dev/ttySL1. Further added, my above >> configuration is working fine on us robotics usbmodem. >> >> >> Please assist me in this problem, I'm stuck in this problem for many days. >> >> -- >> Regards, >> >> Ahmed Munir >> >