Re: How to switch the card into ad-hoc mode?

John,

I have an MA111 card with pre26 driver, but I doubt there is any difference in this case.

Even when the dot11req_start parameters are ok (and your settings look ok to me), I get "resultcode=invalid_parameters" after a successful join.

To test this out, reset by doing this:

wlanctl-ng wlan0 lnxreq_ifstate ifstate=disable
wlanctl-ng wlan0 lnxreq_ifstate ifstate=enable

then issue the dot11req_start and you should see "resultcode=success".

I think the lnx_autojoin should go after that.

Peter


  ----- Original Message ----- 
  From: John 
  To: linux-wlan 
  Sent: Thursday, June 09, 2005 11:07 AM
  Subject: [lwlan-user] How to switch the card into ad-hoc mode?


  Hello,

  I have a D-link DWL-122 wireless USB adapter with linux-wlan-ng-0.2.1-pre25.tar.gz 

  driver.
  When I run "wlanctl-ng wlan0 lnxreq_autojoin ssid=foreignwlan authtype=opensystem ", 

  I get the messages:

  ssid='foreignwlan'
  authtype=opensystem
  resultcode=success

  But when I run "wlanctl-ng wlan0 dot11req_start ssid=foreignwlan bsstype=independent beaconperiod=100 dtimperiod=3 cfpollable=false cfpollreq=false cfpperiod=3 cfpmaxduration=100 probedelay=100 dschannel=6 basicrate1=2 basicrate2=4 operationalrate1=2 operationalrate2=4 operationalrate3=11" to switch the card into ad-hoc mode,

  I get the messages:
  message=dot11req_start
  ssid='foreignwlan'
  bsstype=independent
  beaconperiod=100
  dtimperiod=3
  cfpperiod=3
  cfpmaxduration=100
  fhdwelltime=no_value
  fhhopset=no_value
  fhhoppattern=no_value
  dschannel=6
  ibssatimwindow=no_value
  probedelay=100
  cfpollable=false
  cfpollreq=false
  basicrate1=2
  basicrate2=4
  basicrate3=no_value
  basicrate4=no_value
  basicrate5=no_value
  basicrate6=no_value
  basicrate7=no_value
  basicrate8=no_value
  operationalrate1=2
  operationalrate2=4
  operationalrate3=11
  operationalrate4=no_value
  operationalrate5=no_value
  operationalrate6=no_value
  operationalrate7=no_value
  operationalrate8=no_value
  resultcode=invalid_parameters

  And in the /var/log/messages shows:Jun 1 13:43:11 localhost kernel: prism2mgmt_start: Enable macport failed, result=-22.

  I have notice "resultcode=invalid_parameters", why? How to solve the problem?

  Thanks in advance for any help!

  John







     什么邮箱可以注册长度3位用户名，好记又好用？  



------------------------------------------------------------------------------


  _______________________________________________
  Linux-wlan-user mailing list
  [email protected]
  http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user

_______________________________________________
Linux-wlan-user mailing list
[email protected]
http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user