can't connect after kismet

Chris Bare <[email protected]> Tue, 27 Sep 2005 15:27:27 -0400 (EDT)

Newsgroups	gmane.linux.linux-wlan.user
Message-ID	<[email protected]>

I have wlan-ng-0.2.2 built with kernel 2.6.12. If I run the following:

 wlanctl-ng wlan0 lnxreq_ifstate ifstate=enable
 wlanctl-ng wlan0 lnxreq_autojoin ssid="" authtype=opensystem
 dhcpcd wlan0

I get connected to my AP, no problem.

If I then run Kismet, it works fine, and when I exit I get this message:

WARNING: wlan0 (wlan0) unable to exit monitor mode automatically.  You may
         need to manually restart the device and reconfigure it for normal
         operation.Kismet exiting.

I've tried various combinations of wlanctl-ng commands, but can't seem to find
the magic to "manually restart the device".

Does anyone know the right command(s)?
-- 
Chris Bare
[email protected]