Re: config 1 has an invalid interface number: 1 but max is 0

[email protected] Wed, 26 Oct 2005 10:13:06 -0400

Newsgroups	gmane.linux.linux-wlan.user
Message-ID	<[email protected]>

On Fri, Oct 21, 2005 at 05:30:43PM -0400, Greg Fullerton wrote:
> usb 1-2: new full speed USB device using uhci_hcd and address 65
> usb 1-2: config 1 has an invalid interface number: 1 but max is 0
> usb 1-2: config 1 has no interface number 0

This is a bug in the primary firmware of the card.  I believe it was 
fixed in the 1.1.x series. 

 - Solomon
-- 
Solomon Peachy                        [email protected]
AbsoluteValue Systems                 http://www.linux-wlan.com
721-D North Drive                     +1 (321) 259-0737  (office)
Melbourne, FL 32934                   +1 (321) 259-0286  (fax)

_______________________________________________
Linux-wlan-user mailing list
[email protected]
http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user

signature.asc (application/pgp-signature, 189 B)

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)

iD8DBQFDX47yhinxHf95MjYRAs80AJ9ATBGUx6scYtWYYoNzRSOu8M27KwCfT5NL
j8UY822Iv9svCFtHURI2nsg=
=TcrF
-----END PGP SIGNATURE-----