Re: Passive scan mode

> --- [email protected] wrote:
[...]
> You have to have secondary firmware 1.5.1 or
> newer

I think I have 1.5.6:

linux:~ # wlanctl-ng wlan0 dot11req_mibget
mibattribute=p2PrimaryFWID
message=dot11req_mibget
  mibattribute=p2PrimaryFWID='PO010102.HEX'
  resultcode=success
linux:~ # wlanctl-ng wlan0 dot11req_mibget
mibattribute=p2SecondaryFWID
message=dot11req_mibget
  mibattribute=p2SecondaryFWID='SU010506.HEX'
  resultcode=success
linux:~ # wlanctl-ng wlan0 dot11req_mibget
mibattribute=p2TertiaryFWID
message=dot11req_mibget
  mibattribute=p2TertiaryFWID=''
  resultcode=not_supported
linux:~ #

[...]
>> But I still see beacon frames coming from my
>> station.
> 
> Perhaps you mean probe requests?

Ah yes.  Quite.

So is there a 'go passive' command somewhere?  Or was
the right thing to do, set the passive mode during
initialization as I'd done?

Thanks.

-- 
E



		
__________________________________ 
Yahoo! FareChase: Search multiple travel sites in one click.
http://farechase.yahoo.com