Re: Next try: DWL-122 ifstate=enable failed because wrong firmware

Hi,

On Sat, 17 Jun 2006 18:26:45 +0200 Thomas K wrote:
> > wlanctl-ng wlan0 lnxreq_ifstate ifstate=fwload
> > cat /proc/net/p80211/wlan0/nsd > output.txt
> > echo "------" >> output.txt
> > prism2dl -s wlan0 >> output.txt
> > wlanctl-ng wlan0 lnxreq_ifstate ifstate=disable

I didn't ever thought about firmware uploading:
with this procedere, what firmware file do you load, where
lies the file, where do you get it from?

Maybe that was the problem? Load the wrong file to the stick?
(a file that wasn't capable with the stick modell)




Holger

-- 

==============================================================
Created with Sylpheed-Claws 2.2.2
    under Debian GNU/LINUX 3.1 »Sarge«
        http://counter.li.org/,  Registered LinuxUser #311290
            Spamfiltering by bogofilter.sourceforge.net
=============================================================