Re: Next try: DWL-122 ifstate=enable failed because wrong firmware

Hello Holger,

> So, here's the output file.

thanks for your work. I have compares your file with my output ...  
it's equal! :-(

So I have now no other idea to continue! That's bad. And I have  
checked this also with my old windows box. I had a few time before to  
reinstall this box, so
it was new system and I had to install windows driver again - the  
result: there the stick works, but not on linux!

Maybe there is one thing: with the PRISM flash utility I can read out primary
firmware version and stations firmware version. It shows for primary  
po010102 -
means version 1.1.2 and for secondary ru010801 - its version 1.8.1. But I can
find only a file ru010803.hex!

Is anybody out ther, which has such station firmware file and can send  
it me? Or
has an another idea, which I can try?

cu,
Thomas