Re: TET/vsxgen Installation problems..

Andrew,

   Thanks for you immediate response.. I went into the website for
downloading the testsets and found the following:

harness/
lsb-fhs/
lsb-os/
vsthlite/
vsx-pcts/

  wondering which test set should I choose.. What do these different test
sets refer to ??.

Sai.


********************************************
Saikrishnan Krishnamurthy                  *
Graduate Project Assistant,                *
InterOperability Labs,                     *
University of New Hampshire,               *
Durham, NH - 03824.                        *
                                           *
(off) Tel. Ph - (603) 862 1908             *
                                           *
********************************************

On Wed, 20 Nov 2002, Andrew Josey wrote:

> Sai
> You need to download a testset to install underneath TET/VSXgen.
> The testsets begin lts*gz on the web site
> regards
> Andrew
>
> On Nov 20, 12:42pm in "[lsb-discuss] TET/vs", Saikrishnan Krishnamurthy wrote:
> >
> > Hi all,
> >
> >    I was trying to install the TET/vsxgen framework. I downloaded the
> > tet_vsxgen_2.5.tgz from the TETs website and unzipped it. I then ran the
> > setup.sh.skeleton script that started installing the TET and vsxgen for
> > me. So far so good. Problem arises when the script tries to find the
> > TEST_MODE. The vsxgen subsets directory is all empty and so, the script
> > will not proceed any further and keeps asking me for the TEST_MODE.
> > What does the script expect to be present in the subsets directory ??.
> >    Is there any installation manual for installing the TET/vsxgen ??. I
> > tried reading the vsxgen_spec-1.5r1.pdf. It is extensive and hard to
> > understand for beginers like me..
> >
> > any pointers on these would be greatly appreciated.
> >
> > thanks,
> >
> > Sai.
> >
> >
>