Question about LSB

    I have questions about LSB1.3

Q1) I got different results with the same test set. For example:
    I executed "run_tests" twice on our IPF machine with the user vsx0. 
    I got different results.

  The first result is :   

--------------------------------------------------------------------------------
   Total tests:            8693    PASS = 8670     FAIL = 23

  Pass Breakdown:
  Number of successes:    4556    Number of warnings:     23
  Number unsupported:     114     Number not in use:      3923
  Number of untested:     40      Number of FIP:          14
  Unapproved assertions:  0       Number not implemented: 0

  Failure Breakdown:
  Number of failures:     9       Number unresolved:      14
  Number uninitiated:     0       Number unreported:      0

--------------------------------------------------------------------------------


 and the second result is :

--------------------------------------------------------------------------------

  Total tests:            8657    PASS = 8634     FAIL = 23

  Pass Breakdown:
  Number of successes:    4520    Number of warnings:     23
  Number unsupported:     114     Number not in use:      3923
  Number of untested:     40      Number of FIP:          14
  Unapproved assertions:  0       Number not implemented: 0

  Failure Breakdown:
  Number of failures:     9       Number unresolved:      14
  Number uninitiated:     0       Number unreported:      0

--------------------------------------------------------------------------------


  The users, machine, enviroment are all the same, I can not figure out 
the cause of the differences.

  And another important question: did you get the same result of 2 tests? 
If you tested just once, can you test it again and compare the results?

_______________________________________________
lsb-test mailing list
[email protected]
http://mail.freestandards.org/mailman/listinfo/lsb-test