Re: Data recovery -- thin provisioned LVM metadata (?) problem after hardware failure

Dne 03. 05. 23 v 18:48 haaber napsal(a):
> Dear Zdenek,
>
> I had a forced break, but the subject is still active..
>
>>
>> To get to your thin-pool metadata, you have to activate LV with them.
>> (lvchange -ay  vgname/thinpoolmetadata).
>>
> my pool is called  qubes_dom0/pool00 (now you know my previous operating
> system :) So I tried
>
> lvchange -ay  qubes_dom0/thinpoolmetadata
>
> but that fails:   Failed to find logical volume
> "qubes_dom0/thinpoolmetadata"
>
> Then I tried
>
> lvchange -ay qubes_dom0/pool00_tmeta


Looking at your 'lvs -a' output - you should be able to get this one active.


You will need another LV to write fixed metadata into

# lvcreate -L128M -n newlv  qubes_dom0


Then you run

# thin_repair -i /dev/qubes_dom0/pool00_tmeta -o /dev/qubes_dom0/newlv

If you get some repaired set  which you could probably validate with

  # thin_dump   /dev/qubes_dom0/newlv

if you will some some 'good amount' of some data which describe block mapping 
for many thin volumes.

However if you only see couple lines - basically empty thin-pool metadta - you 
will need to store the content of your original unmodified metadata into a 
compressed file and upload the file for futher exploration.

Let me know what you get from those steps above.


Zdenek



--
lvm-devel mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/lvm-devel