Re: wifi - carte PCI WMP54G

"[email protected]" <[email protected]>
Newsgroups gmane.linux.mandrake.expert.french
Message-ID <[email protected]>
Jean-Baptiste BUTET a écrit :
> Salut :)
>
> On va faire les choses dans l'ordre :
>
> 1) ndiswrapper marche donc on va le laisser.
>
> Tu reviendras a du "libre saybonmangezen" après.
>
> ----------
> [root@localhost ~]# iwlist wlan0 scan
> wlan0     Scan completed :
>         Cell 01 - Address: 00:18:4D:04:16:CC
>                   ESSID:"NETGEAR"
>                   Protocol:IEEE 802.11g
>                   Mode:Managed
>                   Frequency:2.462 GHz (Channel 11)
>                   Quality:0/100  Signal level:-75 dBm  Noise
> level:-256 dBm
>                   Encryption key:off
>                   Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
>                             6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
>                             36 Mb/s; 48 Mb/s; 54 Mb/s
>                   Extra:bcn_int=100
>                   Extra:atim=0
> -----------
>
> Bon pas de problèmes donc : il voit ton AP.
>
> ------------
>
> [root@localhost ~]# iwconfig wlan0 essid NETGEAR
> [root@localhost ~]# iwconfig
> lo        no wireless extensions.
>
> eth0      no wireless extensions.
>
> sit0      no wireless extensions.
>
> wlan0     IEEE 802.11g  ESSID:"NETGEAR"
>         Mode:Managed  Frequency:2.462 GHz  Access Point: 
> 00:18:4D:04:16:CC
>         Bit Rate:18 Mb/s   Tx-Power:20 dBm   Sensitivity=-121 dBm
>         RTS thr:2347 B   Fragment thr:2346 B
>         Encryption key:off
>         Power Management:off
>         Link Quality:100/100  Signal level:-77 dBm  Noise level:-256 dBm
>         Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>         Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> --------
>
> En plus il a accroché, c'est y pas terriblous ca ?????????
>
> [root@localhost ~]# ifconfig
> wlan0     Link encap:Ethernet  HWaddr 00:18:39:17:FA:58
>         adr inet6: fe80::218:39ff:fe17:fa58/64 Scope:Lien
>         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>         RX packets:3 errors:0 dropped:0 overruns:0 frame:0
>         TX packets:0 errors:0 dropped:1 overruns:0 carrier:0
>         collisions:0 lg file transmission:1000
>         RX bytes:126 (126.0 b)  TX bytes:0 (0.0 b)
>         Interruption:21 MÃ(c)moire:febf0000-febf8000
> ----------
>
> il te file pas d'adresse ip mais bon :
>
> [root@localhost ~]# dhclient
> DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 13
> ---------
>
> Tu dois connaitre ton adressage ip j'imagine :
> donc on va tenter de se mettre en ip fixe :
>
> ifconfig wlan0 192.168.1.101
>
> puis tu ping ta passerelle.
> Si ca ping :
>
> route add default gw mettre_ici_l_ip_de_la_passerelle
>
> puis tu edites /etc/resolv.conf pour mettre tes DNS pour aller sur le 
> net.
>
> J'espere que ca marchera :)
>
> JB
>
> NB : ne t'embete plus pour le moment avec rt2500. On verra ca plus tard. 

Ok, j'ai donc essayer d'attribuer la même ip que sous windows à savoir 
192.168.0.3 pour une passerelle se trouvant à l'adresse 192.168.0.1 :

[root@localhost ~]# iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

sit0      no wireless extensions.

wlan0     IEEE 802.11g  ESSID:"NETGEAR"
          Mode:Managed  Frequency:2.462 GHz  Access Point: 00:18:4D:04:16:CC
          Bit Rate:11 Mb/s   Tx-Power:20 dBm   Sensitivity=-121 dBm
          RTS thr:2347 B   Fragment thr:2346 B
          Encryption key:off
          Power Management:off
          Link Quality:100/100  Signal level:-81 dBm  Noise level:-256 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

[root@localhost ~]# ifconfig wlan0 192.168.0.3
[root@localhost ~]# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data.
 From 192.168.0.3 icmp_seq=2 Destination Host Unreachable
 From 192.168.0.3 icmp_seq=3 Destination Host Unreachable
 From 192.168.0.3 icmp_seq=4 Destination Host Unreachable

--- 192.168.0.1 ping statistics ---
5 packets transmitted, 0 received, +3 errors, 100% packet loss, time 4001ms
, pipe 3
[root@localhost ~]# 


Quel est le problème ?
Merci à tous vos réponses.
message-footer.txt (text/plain, 232 B)
____________________________________________________
Want to buy your Pack or Services from Mandriva? 
Go to http://store.mandriva.com
Join the Club : http://www.mandrivaclub.com
____________________________________________________
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.