Re: qmake and make on 2010.0

Rick Kunath wrote:
> On Monday 22 March 2010 06:42:57 pm Rodney wrote:
> 
>>>> I am trying to build a version of a program called linpsk.  "qmake"
>>>> now works but when I try "make" I get a number of error messages,
>>>> starting with:-
>>>> "g++; command not found"
>>>> "[general settings.o] Error 127"
> 
> Is that even a qt4 app?
> 
> Lots of older apps won't build on KDE4 unmodified easily.
> 
> Why would you want to build Linpsk anyway?
> 
> Have you seen Fldigi? Infinitely better and under current development.
> 
> Rick Kunath


Thanks to Rick for the suggestion of looking at fldigi; I have now built 
it for Mandy 2008.1 and it is working well.  It is clearly very well 
presented and is a nice looking gui.  However, it only appears to accept 
one signal at a time and each signal selected goes into the same text 
box so that it is not clear where one ends and another begins.  This is 
a poor comparison with the best Win version I have found (I think it is 
W1SQLPSK but can't check as I am in Linux mode) and this will do 10 
signals or more, each in a separate box.  Interestingly it turns the 
waterfall through 90deg and so each signal can have its own text 
streamer horizontally beside it.

I am sure there is a more appropriate forum for this; perhaps someone 
will point me to it.

Thanks for the suggestions,

Rod
____________________________________________________
Want to buy your Pack or Services from Mandriva? 
Go to http://store.mandriva.com
Join the Club : http://www.mandrivaclub.com
____________________________________________________