RE: [Security Firewall] Problem with port forwarding

the router is using NAT, i also had tried:
DNAT    wan      lan:192.168.1.101      tcp     ftp    -    public_ip

and doesn´t work.
i don´t know what i´m doing wrong:((

>Assuming your LAN is using NAT, none of these will work because you have to
>specify the public IP in the forward portion of the DNAT rule.  (it has to
>know where to listen)
>
>Here is a rule that we use to gain SSH into a linux box within the lan from
>the wan (where xxx is your public IP)
>
>DNAT    wan      lan:192.168.69.3       tcp     ssh     -
>xxx.xxx.xxx.xxx
>
>ftp and ftp-data would be the same.  Be sure and remove those other rules.
>Jim


>From: "ibon M. B." <[email protected]>
>Reply-To: security-firewall-4qZELD6FgxheH41UXmfQsti2O/[email protected]
>To: security-firewall-J4tZAbal8pkzaQFa27Lw39BPR1lH4CV8@public.gmane.org
>Subject: [Security Firewall] Problem with port forwarding
>Date: Tue, 14 Jun 2005 10:06:26 +0000
>
>Thanks for your help
>I have created a custom rule to forward the ftp traffic to a computer in my 
>lan, but port forwarding doesn´t seem to work.
>Custom Rule:
>Result --DNAT
>Predefined Services--FTP
>Protocol--FTP
>Client:WAN
>Server:LAN 192.168.1.100
>Forwarding Address:all
>
>i can connect the ftp server inside the lan, but not outside.
>any ideas?
>
>
>
>____________________________________________________
>Want to buy your Pack or Services from MandrakeSoft?
>Go to http://www.mandrakestore.com
>Join the Club : http://www.mandrakeclub.com
>____________________________________________________

____________________________________________________
Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com
Join the Club : http://www.mandrakeclub.com
____________________________________________________