Re: CentOS 7: restore fails (Bruno Cornec)

On 22/12/2016 12:47 μμ, Simon Magrin wrote:

> "Keep using the -z option, especially if you use SELinux ! Without it,
> your system won't allow you to log in after restore."
>
> This issue has caught me out before. A workaround is to;
>
>    - Change SELinux to 'permissive' by mounting the newly restored volume
> and editing /etc/selinux/coonfig or
>
>    - booting into Single mode, log in as root run 'fixfiles -relabel',
> change change back to 'enforcing' and reboot.

Thanks Simon,

All the restores I have tried were from backups which were using the -z 
option. However, I have SELinux disabled, so this is not an issue.

(I am using the -z option mainly due to our occasional use of extended 
file permissions (ACL).)

The problem is that the restored VM won't boot at all in all of my tests.

Cheers,
Nick

------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today.http://sdm.link/intel
_______________________________________________
Mondo-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mondo-devel