Re: CentOS 7: restore fails

On 26/12/2016 1:47 πμ, Bruno Cornec wrote:

> Well somehow yes, it helps.
> In your case grub doesn't install correctly.

I tried amending /boot/grub2/device.map and rebooting, but nothing 
changed. You advised me to run grub2-install but at the end of all these 
automatic restores, there is nothing in the /mnt/RESTORING directory. 
What should I do, if I try again?

Following my unsuccessful "Automatic" recoveries (nuke),  I tried two 
more times using the Interactive restore method; I did not modify 
anything during the restore process, except that I commented out an nfs 
mount in /etc/fstab.

I did not rebuild initrd; In fact, I don't know if I should (I am 
restoring to the same geometry), and even if I should, I don't know how 
to do it on CentOS 7 (ramfs etc.). If I should, can someone provide 
directions on how to do it?

In both cases it seems I faced some bug at the last stage because the 
restore did not end up gracefully. See attached image.

In both cases the generated mondorestore.log was not available (when I 
booted with Knoppix), so in the third restore effort I took care to copy 
it safely beforehand.

Here are links to the mondoarchive.log of the backup taken and the 
mondorestore.log of the (failed) interactive restore:

    http://iweb.noa.gr/files/mondoarchive-nm-20170104-01.log
    http://iweb.noa.gr/files/mondorestore-nm-20170104-01.log

Needless to say, these restores won't boot either.

Please advise on how to move forward!!

Thanks a lot,
Nick

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most 
engaging tech sites, SlashDot.org! http://sdm.link/slashdot

_______________________________________________
Mondo-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mondo-devel