Re: Mindi runs out of space on RHEL7

Yes, thank you
Setting it to that larger figure did the trick for me.
I was able to complete the image capture after this change.
Thanks a bunch
--
Steven DuChene


 On Thursday, November 14, 2019, 12:54:55 PM EST, rafa <[email protected]> wrote: 


Sorry, I think my message is not correct about the /tmp filesystem. I have faced similar problems while mondo generates an image and uses the default /tmp dir as temporal storage. 

Try increasing the EXTRA_SPACE to 600000 as suggested in this thread:

https://sourceforge.net/p/mondo/mailman/message/36081631/ 

Best Regards. 
rafa

On Thu, Nov 14, 2019 at 6:46 PM rafa <[email protected]> wrote:
> Hi Steven,
> 
> The message:
> cp: error writing ‘/tmp/mondo.tmp.jIc5gl/mountpoint.27329/tmp/mountlist.txt’: No space left on device 
> 
> Suggests that you are running out of space in the /tmp filesystem.
> 
> Try mondoarchive with a different temp dir (-T)
> 
> best regards,
> rafa
>  
> 
> On Thu, Nov 14, 2019 at 4:21 PM Steven DuChene via Mondo-devel <[email protected]> wrote:
>> Does anyone monitor this list?
>> I sent a message a few days ago and I got a message back saying my message to the list was held up waiting for moderator approval.
>> I am in the middle of a project where I am trying to use mondo to capture an image of a system and the issue I reported is a showstopper.
>> Thanks
>> 
>> --
>> Steven DuChene
>> 
>> On Tuesday, November 12, 2019, 8:55:34 PM EST, Steven DuChene <[email protected]> wrote: 
>> 
>> I have installed Mondo Archive v3.2.2-r3578 and mindi v3.0.2-r3578 onto a RHEL7 system (RHEL 7.7 to be exact) and when I run the mondoarchive command it fails with an error of 'Failed to generate boot+data disks' and mindi says it is running out of space with an error of ‘/tmp/mondo.tmp.jIc5gl/mountpoint.27329/tmp/mountlist.txt’: No space left on device
>> 
>> cp: error writing ‘/tmp/mondo.tmp.jIc5gl/mountpoint.27329/tmp/mountlist.txt’: No space left on device
>> 
>> After looking around on the mondo archives and FAQs I tried setting the following parameters in the mindi configuration file:
>> 
>> EXTRA_SPACE=300000
>> BOOT_SIZE=40960
>> 
>> but the problem still occurs.
>> 
>> The mindi.log file I have attached below does indicate there are 5 or 6 kernels installed on the system due to previous upgrades.
>> However I don't know if this is the problem with the above failure or not.
>> 
>> Any suggestions would be appreciated.
>> --
>> Steven DuChene
>> 
>> 
>> _______________________________________________
>> Mondo-devel mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/mondo-devel
>> 
> 


_______________________________________________
Mondo-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mondo-devel