Some help!!
ramsurrunv-aD7nsNzqxXzCK/[email protected]
| Newsgroups | gmane.linux.network.bridge.ebtables.user |
|---|---|
| Message-ID | <[email protected]> |
Hi to all, I need some help. I'm using the following rule: ebtables -t nat -A OUTPUT -p ipv4 -o eth0 -j dnat --to-destination 00:50:ba:3a:64:1f I'm using only this rule and all the policies are set to the default setting (ACCEPT), RH9 with an upgraded kernel of 2.6.13 and ebtables v2.0.6. When I issue ebtables -t nat -L --Lc, the packet count, pcnt, is zero. The above rule is not having the desired effect. I tried again after disabling iptables but it didn't work. I even formatted and re-installed everything but still no success. Does anyone have an idea why it might be so? Warm regards, Visham ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl