Question on manual bridging.
Ben Greear <greearb-my8/[email protected]>
| Newsgroups | gmane.linux.network.bridge.ebtables.user |
|---|---|
| Organization | Candela Technologies |
| Message-ID | <[email protected]> |
Suppose I have a wifi interface 'ms1' and an ethernet interface eth0. Connected to eth0 is a PC with MAC address AA, which is exactly the same MAC address as ms1 has. Is there a way to make ebtables forward all packets from ms1 to eth0 (un-changed), and have all packets from eth0 with source-MAC of AA be forwarded to ms1? I want this setup to be as transparent as possible, so if I don't have to have any IP addresses on the ms1 and eth0 interface, that is best. I'm an ebtables newbie, so if someone could send me an example of doing this, I would be greatful! Thanks, Ben -- Ben Greear <greearb-my8/[email protected]> Candela Technologies Inc http://www.candelatech.com ------------------------------------------------------- This SF.Net email is sponsored by the JBoss Inc. Get Certified Today Register for a JBoss Training Course. Free Certification Exam for All Training Attendees Through End of 2005. For more info visit: http://ads.osdn.com/?ad_id=7628&alloc_id=16845&op=click