[PATCH net v2 2/6] net: dsa: mt7530: check bus->read() error in core_rmw()

core_rmw() accesses the MMD core registers directly rather than
through the regmap and has the same unchecked bus->read() as the
one just fixed in the MDIO regmap backend: a negative errno is
consumed as register data, modified and written back to the switch.
Check the read and bail out like the surrounding bus accesses do.

Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch")
Signed-off-by: Daniel Golle <[email protected]>
Reviewed-by: Andrew Lunn <[email protected]>
---
v2: no changes

 drivers/net/dsa/mt7530.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index aa33d94e11b5..9be6fb63c311 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -124,8 +124,12 @@ core_rmw(struct mt7530_priv *priv, u32 reg, u32 mask, u32 set)
 		goto err;
 
 	/* Read the content of the MMD's selected register */
-	val = bus->read(bus, MT753X_CTRL_PHY_ADDR(priv->mdiodev->addr),
+	ret = bus->read(bus, MT753X_CTRL_PHY_ADDR(priv->mdiodev->addr),
 			MII_MMD_DATA);
+	if (ret < 0)
+		goto err;
+	val = ret;
+
 	val &= ~mask;
 	val |= set;
 	/* Write the data into MMD's selected register */
-- 
2.55.0