Sugested tests.

Bill,

I have installed 1.9.0 on my test box and the test_str03 -d 5 -b 5 fails
with a segfault.  Although make test works with no problems.

I have also tested siege compiled with linuxthreads against tux in the
kernel.  The performance is excellent but eventually I will get exceptions
in siege or in the kernels scheduler itself.

On a good note the same test run with ngpt 1.9.0 ran for over two hours but
was easyly at least 50% slower.

With tux I was serving a .html and about 40 images to siege. Maybe this is a
way you can help tune 1.9.x for use with the kernel.

I was also hoping you could help me with something, my understanding that
was after installing ngpt if I recompiled the kernel, etc it too would use
it?  Is there a way to verify that it's not using linuxthreads .9 and
instead 1.9?

Steven