Re: NGPT 1.9.90, NGPT 2.0 RELEASE CANDIDATE 1 RELEASED

[email protected] Mon, 24 Jun 2002 10:21:15 -0400
Newsgroups gmane.linux.ngpt.user
Message-ID <[email protected]>
On 06/24/2002 at 03:55:09 PM ZE2, Wessel Dankers <[email protected]> wrote:
>
> On 2002-06-24 09:14:24-0400, [email protected] wrote:
> > NGPT Release 1.9.90 is the first release candidate of NGPT 2.0.
>
> Great!
>
> However, I could not get it to compile:
>
> ./libtool --mode=link --quiet gcc -s -o test_pthread test_pthread.o
> test_common.o libpthread.la -lnsl
> .libs/libpthread.so: undefined reference to `pthread_initialize'
> .libs/libpthread.so: undefined reference to `pthread_shutdown'
> collect2: ld returned 1 exit status
>
> (NGPT 1.9.3 did compile without a hitch).

How did you do the build of NGPT?  Did you install from the rpm (although
if I remember right, you're a Debian person ;-) or build from source?  If
you build from source, how did you run configure?  The proper way would be
one of the following:
      -     Source the .aliases files in the ngpt route directory
      -     Then enter: "bt install", followed by "make install"

            or

      -     Run "./configure --with-param=install" followed by "make
install"

If you ran it either of these two ways, can you please send me your
"config.status" file from your NGPT directory?

Thanks.

Regards,
     Bill Abt
     Senior Software Engineer
     Next Generation POSIX Threading for Linux
     IBM Cambridge, MA, USA 02142
     Ext: +(00)1 603-673-3440
     T/L: 253-9938
     Cell: +(00)1 617-803-7514
     [email protected] or [email protected]
     http://oss.software.ibm.com/developerworks/opensource/pthreads