Re: Cento round robin or full flow to multiple destinations

Alexander
cento sends to all destinations simultaneously

Luca

> On 28 Feb 2017, at 18:41, Jesse Alexander <[email protected]> wrote:
> 
> Hello,
> 
> We are using Cento to send netflow to multiple destinations.
> 
> In the nprobe help file, I see there is a -a option to send full flows to all destinations.  I do not see this as an option in the Cento help file.
> 
> [--collector|-n] <host:port|none> | Address of the NetFlow collector(s).
> | Multiple collectors can be defined using
> | multiple -n flags. In this case flows
> | will be sent in round robin mode to
> | all defined collectors if the -a flag
> | is used. Note that you can specify
> | both IPv4 and IPv6 addresses.
> | If you specify none as value,
> | no flow will be export; in this case
> | the -P parameter is mandatory.
> | Note that you can specify the protocol
> | used to send packets. Example:
> | udp://192.168.0.1:2055,tcp://10.1.2.3:2055 
> 
> [--all-collectors|-a] | If several collectors are defined, this
> | option gives the ability to send all
> | collectors all the flows. If the flag is
> | omitted collectors are selected in
> | round robin.
> 
> Is this supported in Cento?  If not, is cento sending round robin or full flows to all destinations?
> 
> Kind regards,
> 
> Jesse
> 
> 
> _______________________________________________
> Ntop mailing list
> [email protected]
> http://listgateway.unipi.it/mailman/listinfo/ntop