Re: IPv6
Luca Deri <[email protected]>
| Newsgroups | gmane.linux.ntop.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Matthias just generate a pcap with wireshark where you filter just flows. Until a template is received, wireshark is unable to decode the traffic, so you can stop *after* wireshark is able to decode the flows as it means that the template has been received Luca > On 6 Apr 2017, at 15:53, Matthias Henze <[email protected]> wrote: > > Hi Luca, > > generation a pcap is no problem, but what is a "template" in this context? > > TIA > Matthias > > Am 05.04.2017 um 21:24 schrieb Luca Deri: >> Hi Matthias >> perhaps the template the Mikrotik is using is not handled properly. Can you please send me (not to the list) a pcap containing template+some IPv6 flows? >> >> Thanks Luca >> >>> On 5 Apr 2017, at 17:25, Matthias Henze <[email protected]> wrote: >>> >>> Hi, >>> >>> I use NetFolow to send traffic data from my Microtik routers to Nprobe and Ntop. This works as expected for IPv4 but no IPv6 traffic is recorded. What may cause this? >>> >>> TIA >>> Matthias >>> >>> >>> -- >>> >>> MHC SoftWare GmbH >>> Fichtera 17 >>> 96274 Itzgrund/Germany >>> voice: +49-(0)9533-92006-0 >>> fax: +49-(0)9533-92006-6 >>> e-mail: [email protected] >>> >>> HR Coburg: B2242 >>> Geschaeftsfuehrer: Matthias Henze >>> >>> >>> >>> _______________________________________________ >>> Ntop mailing list >>> [email protected] >>> http://listgateway.unipi.it/mailman/listinfo/ntop >> >> _______________________________________________ >> Ntop mailing list >> [email protected] >> http://listgateway.unipi.it/mailman/listinfo/ntop >> > > > -- > > MHC SoftWare GmbH > Fichtera 17 > 96274 Itzgrund/Germany > voice: +49-(0)9533-92006-0 > fax: +49-(0)9533-92006-6 > e-mail: [email protected] > > HR Coburg: B2242 > Geschaeftsfuehrer: Matthias Henze > > > > _______________________________________________ > Ntop mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop