Re: Interface Views with Dynamic Flow Collection Interfaces
Simone Mainardi <[email protected]>
| Newsgroups | gmane.linux.ntop.general |
|---|---|
| Message-ID | <[email protected]> |
Hi Ryan, > On 21 Jul 2017, at 18:38, Ryan Gelobter <[email protected]> wrote: > > Is there anyway to use the Interface Views feature while also using the Dynamic Flow Collection Interfaces feature based on Probe IP Address? > Currently, this is not supported. However, you can do the following: instruct your Datacenter1 edge01 and edge02 routers to export flows also to another instance of nprobe listening on a different port. Then start that nprobe (but this time don't use the %EXPORTER_IPV4_ADDRESS in the template) and use zmq with another endpoint, say tcp://*:5557 <tcp://*:5557> Finally, start your ntopng with an extra interface that collects data from the latter endpoint with -i tcp://127.0.0.1:5557 <tcp://127.0.0.1:5557> Regards, Simone > Example: > We export flows from 10 different routers (edge01/edge02) in 5 different datacenters. I'd like a interface view for Datacenter1 to include its edge01 and edge02 routers. > > Even if I have to know the Probe IP address in advanced and specify it on cmd line, that is fine but the dynamic interfaces are not named what I think the Interface Views feature would expect or reference. > > Thanks, > Ryan > _______________________________________________ > Ntop mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop