Re: nprobe config question
Simone Mainardi <[email protected]>
| Newsgroups | gmane.linux.ntop.general |
|---|---|
| Message-ID | <[email protected]> |
Hi David, Please, see below inserted replies, > On 16 Aug 2017, at 17:45, David Kraut <[email protected]> wrote: > > Hi All, > > I have ntopng v3 running on Ubuntu 16 and I believe I have nprobe running as expected on a remote box, which is sending netflow to ntopng. As a sanity check, could someone tell me the command line to start nprobe assuming I'm running it on a separate server and only using it as a remote feed for my ntopng server? nprobe being fed by a switch span port and then sending the corresponding netflow to my central ntopng server. ./nprobe -i your_input_span_port -n none --zmq tcp://*:5556 <tcp://*:5556> ./ntopng -i tcp://<nprobe_host_ip_address <tcp://<nprobe_host_ip_address>>:5556 > > Also, when installing nprobe in this remote feed scenario, can I just run "apt-get install nprobe" you can just run this > or is it best practice to run > > apt-get install pfring nprobe ntopng ntopng-data n2disk cento nbox > Thanks, > > David > _______________________________________________ > Ntop mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop