Re: netflow + ntop on BGP
Simone Mainardi <[email protected]>
| Newsgroups | gmane.linux.ntop.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, Very likely you are monitoring plain NetFlow traffic without interpreting its contents. Please, refer to this resource for proper setup: https://www.ntop.org/nprobe/why-nprobejsonzmq-instead-of-native-sflownetflow-support-in-ntopng/ <https://www.ntop.org/nprobe/why-nprobejsonzmq-instead-of-native-sflownetflow-support-in-ntopng/> Simone > On 4 Feb 2018, at 15:12, Joni Lee <[email protected]> wrote: > > Hello, > > Is there any documentation for this ? > > I am using Cisco ASR 1001-X and already setup flow exporter, record and monitor in my router. On other side ntop + nprobe also setup. Now, I only saw only one flow from router to ntop+nprobe machine for example a.b.c.d:port => x.x.x.x:2055 (Netflow). > > -- > Sincerely, > Joni Lee > Office: +886(4)2311-7977 > Mobile: +886-970-576-524 > HostingInside LTD. / 鷹式特網有限公司 / AS134522 > _______________________________________________ > Ntop mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop